Your search

Two sediment cores obtained from the continental shelf of the northern South Shetland Islands, West Antarctica, consist of: an upper unit of silty mud, bioturbated by a sluggish current, and a lower unit of well-sorted, laminated silty mud, attributed to an intensified Polar Slope Current. Geochemical and accelerator mass spectrometry 14C analyses yielded evidence for a late Holocene increase in sea-ice extent and a decrease in phytoplankton productivity, inferred from a reduction in the total organic carbon content and higher C : N ratios, at approximately 330 years B.P., corresponding to the Little Ice Age. Prior to this, the shelf experienced warmer marine conditions, with greater phytoplankton productivity, inferred from a higher organic carbon content and C : N ratios in the lower unit. The reduced abundance of Weddell Sea ice-edge bloom species (Chaetoceros resting spores, Fragilariopsis curta and Fragilariopsis cylindrus) and stratified cold-water species (Rhizosolenia antennata) in the upper unit was largely caused by the colder climate. During the cold period, the glacial restriction between the Weddell Sea and the shelf of the northern South Shetland Islands apparently hindered the influx of ice-edge bloom species from the Weddell Sea into the core site. The relative increases in the abundance of Actinocyclus actinochilus and Navicula glaciei, indigenous to the coastal zone of the South Shetland Islands, probably reflects a reduction in the dilution of native species, resulting from the diminished influx of the ice-edge species from the Weddell Sea. We also document the recent reduction of sea-ice cover in the study area in response to recent warming along the Antarctic Peninsula.

An analysis is presented of high-frequency (HF) signals from the European Incoherent Scatter HF ionospheric modification transmitter received during 26–30 October 2002 at three sites, two in Europe and one in Antarctica. Two components with different characteristics (“mirror-reflected” and “scattered”) were observed in the signal spectra. The mirror-reflected component can be associated with radiation through the side lobes of the transmitting antenna thus bypassing the modified volume on its way to the receiving sites. In contrast, the scattered component was radiated through the main antenna beam and then scattered by pump-induced ionospheric irregularities above the heater. As a result, variations in the scattered component signal intensity and Doppler frequency shifts (DFS) recorded at the greatly separated sites showed a high level of correlation. It is shown that the Doppler frequency variations can be associated with variations in the plasma density and/or physical motion velocities of stimulated inhomogeneities within the volume common to all propagation paths. Analysis of Doppler frequency shifts at greatly separated sites would allow identifying the mechanism responsible for the self-scattering effect. In the case of DFSs due to motion of the pump-induced scatterers it would be also possible to reconstruct the full velocity vector of the inhomogeneities.

If the reader is looking for another rehashing of one of the adventures of the “Heroic Era” of Antarctic exploration, or another reshaping of the same old material about the three or four explorers from that period who get all the attention, M.L. Paine’s Footsteps on the ice: the Antarctic diaries of Stuart D. Paine, Second Byrd Expedition is not the book for you. But if you are a serious Antarctic buff who wants to learn something new, and really get inside one of the early expeditions of the 20th century, Paine’s volume will be a compelling read.

The East Antarctic Ice Sheet is the largest, highest, coldest, driest, and windiest ice sheet on Earth. Understanding of the surface mass balance (SMB) of Antarctica is necessary to determine the present state of the ice sheet, to make predictions of its potential contribution to sea level rise, and to determine its past history for paleoclimatic reconstructions. However, SMB values are poorly known because of logistic constraints in extreme polar environments, and they represent one of the biggest challenges of Antarctic science. Snow accumulation is the most important parameter for the SMB of ice sheets. SMB varies on a number of scales, from small-scale features (sastrugi) to ice-sheet-scale SMB patterns determined mainly by temperature, elevation, distance from the coast, and wind-driven processes. In situ measurements of SMB are performed at single points by stakes, ultrasonic sounders, snow pits, and firn and ice cores and laterally by continuous measurements using ground-penetrating radar. SMB for large regions can only be achieved practically by using remote sensing and/or numerical climate modeling. However, these techniques rely on ground truthing to improve the resolution and accuracy. The separation of spatial and temporal variations of SMB in transient regimes is necessary for accurate interpretation of ice core records. In this review we provide an overview of the various measurement techniques, related difficulties, and limitations of data interpretation; describe spatial characteristics of East Antarctic SMB and issues related to the spatial and temporal representativity of measurements; and provide recommendations on how to perform in situ measurements.

Single-grain (U-Th)/He ages from two profiles were used to reconstruct the post-Permian tectonic-thermal history of basement rocks in Heimefrontfjella, East Antarctica. The (U-Th)/He ages from one sample collected below the late Carboniferous/Early Permian sedimentary cover rocks indicate Jurassic–Early Cretaceous basement paleotemperatures of ∼40°–60°C due to post-Permian burial. Combined apatite fission track and (U-Th)/He analyses from samples of a profile in Sivorgfjella suggest a period of flexural-related tilting after ∼87 Ma. The timing was further constrained using forward and inverse models of the (U-Th)/He data. Model results indicate a Cenozoic phase of relatively rapid cooling from ∼40°C to surface temperatures. As the driving mechanism, we propose flexural isostatic rebound due to glacial load during the development of the intracontinental ice sheet in the hinterland of the Heimefrontfjella region.

April is here and we have just passed the midpoint of the International Polar Year (IPY), which began on 1 March 2007 and will conclude on 1 March 2009. The “year” stretches over 24 months to accommodate two summer field seasons in both polar regions. The northern summer is fast approaching, and scientists who will undertake a second IPY summer season in the Arctic are making their final preparations. At the opposite end of the planet, summer is over and scientists have wrapped up the first IPY field season. Those whose projects will carry on for a second summer season will have to wait until late this year to resume work in Antarctica.

The snow surface roughness at centimetre and millimetre scales is an important parameter related to wind transport, snowdrifts, snowfall, snowmelt and snow grain size. Knowledge of the snow surface roughness is also of high interest for analyzing the signal from radar sensors such as SAR, altimeters and scatterometers. Unfortunately, this parameter has seldom been measured over snow surfaces. The techniques used to measure the roughness of other surfaces, such as agricultural or sand soils, are difficult to implement in polar regions because of the harsh climatic conditions. In this paper we develop a device based on a laser profiler coupled with a GPS receiver on board a snowmobile. This instrumentation was tested successfully in midre Lovénbreen, Svalbard, in April 2006. It allowed us to generate profiles of 3 km sections of the snow-covered glacier surface. Because of the motion of the snowmobile, the roughness signal is mixed with the snowmobile signal. We use a distance/frequency analysis (the empirical mode decomposition) to filter the signal. This method allows us to recover the snow surface structures of wavelengths between 4 and 50 cm with amplitudes of >1 mm. Finally, the roughness parameters of snow surfaces are retrieved. The snow surface roughness is found to be dependent on the scales of the observations. The retrieved RMS of the height distribution is found to vary between 0.5 and 9.2 mm, and the correlation length is found to be between 0.6 and 46 cm. This range of measurements is particularly well adapted to the analysis of GHz radar response on snow surfaces.

In the century since Roald Amundsen and Robert F. Scott led the first and second expeditions to reach the South Pole, commentators have frequently passed judgement on the different means of transport that the two explorers employed. In hindsight, and since he ‘won,’ they have consistently praised Amundsen for using dogs exclusively and criticised Scott for not doing the same. Surprisingly, however, almost no attention has been given to the experience of Amundsen's dogs, whose extreme suffering seems to have vanished into a collective blind spot. Here, with the aim of restoring balance to one part of the vexed historiography of the two explorers, that record is set straight. Amundsen's troubled and contradictory attitude towards his animals is also explored and common misconceptions about Scott's views on the use of dogs for transport are confuted.

Bioremediation in cold climates is frequently regarded with skepticism. Owners of polluted sites and regulatory agencies may doubt the effectiveness of biological degradation at near freezing temperatures. While it is true that biodegradation rates decrease with decreasing temperatures, this does not mean that bioremediation is inappropriate for cold regions. Microbial degradation of hydrocarbons occurs even around 0 °C (Chapter 4). In remote alpine, Arctic, and Antarctic locations, excavation and shipping of contaminated soil may be prohibitively expensive. Bioremediation may be the most cost-effective alternative. This chapter discusses microbial adaptation to cold temperatures as well as results of laboratory and field studies of bioremediation at low temperatures.Microorganisms can grow at temperatures ranging from subzero to more than 100 °C. Microbes are divided into four groups based on the range of temperature at which they can grow. The psychrophiles grows at temperatures below 20 °C, the mesophiles between 20 °C and 44 °C, the thermophiles between 45 °C and 70 °C, and the hyperthermophiles require growth temperatures above 70 °C to over 110 °C. The term “cold-adapted microorganisms” (CAMs) is frequently used for describing bacteria growing at or close to zero degrees Celsius. Depending on the cardinal temperatures (the minimal, the optimal, and the maximum growth temperature), CAMs can be classified as psychrophiles or psychrotrophs. Morita's (1975) definition, which holds that psychrophiles have a maximum growth temperature of less than 20 °C and an optimal growth temperature of less than 15 °C, while psychrotrophs have a maximum temperature of 40 °C and an optimal growth temperature higher than 15 °C, is widely accepted.

Oil and fuel spills are among the most extensive and environmentally damaging pollution problems in cold regions and are recognized as potential threats to human and ecosystem health. It is generally thought that spills are more damaging in cold regions, and that ecosystem recovery is slower than in warmer climates (AMAP 1998; Det Norske Veritas 2003). Slow natural attenuation rates mean that petroleum concentrations remain high for many years, and site managers are therefore often forced to select among a range of more active remediation options, each of which involves a trade-off between cost and treatment time (Figure 11). The acceptable treatment timeline is usually dictated by financial circumstance, perceived risks, regulatory pressure, or transfer of land ownership.In situations where remediation and site closure are not urgent, natural attenuation is often considered an option. However, for many cold region sites, contaminants rapidly migrate off-site (Gore et al. 1999; Snape et al. 2006a). In seasonally frozen ground, especially in wetlands, a pulse of contamination is often released with each summer thaw (AMAP 1998; Snape et al. 2002). In these circumstances natural attenuation is likely not a satisfactory option. Simply excavating contaminants and removing them for off-site treatment may not be viable either, because the costs are often prohibitive and the environmental consequences of bulk extraction can equal or exceed the damage caused by the initial spill (Filler et al. 2006; Riser-Roberts 1998).