Your search

We present a model for the growth of frazil ice crystals and their accumulation as marine ice at the base of Antarctic ice shelves. The model describes the flow of buoyant water upward along the ice shelf base and includes the differential growth of a range of crystal sizes. Frazil ice formation starts when the rising plume becomes supercooled. Initially, the majority of crystals have a radius of ?0.3 mm and concentrations are below 0.1 g/L. Depending on the ice shelf slope, which controls the plume speed, frazil crystals increase in size and number. Typically, crystals up to 1.0 mm in radius are kept in suspension, and concentrations reach a maximum of 0.4 g/L. The frazil ice in suspension decreases the plume density and thus increases the plume speed. Larger crystals precipitate upward onto the ice shelf base first, with smaller crystals following as the plume slows down. In this way, marine ice is formed at rates of up to 4 m/yr in some places, consistent with areas of observed basal accumulation on Filchner-Ronne Ice Shelf. The plume continues below the ice shelf as long as it is buoyant. If the plume reaches the ice front, its rapid rise produces high supercooling and the ice crystals attain a radius of several millimeters before reaching the surface. Similar ice crystals have been trawled at depth north of Antarctic ice shelves, but otherwise no observations exist to verify these first predictions of ice crystal sizes and volumes.

The ocean cavity beneath Filchner-Ronne Ice Shelf is observed to respond to the seasonal cycle of water mass production on the continental shelf of the southern Weddell Sea. Here we use a numerical model to investigate the propagation of newly formed shelf waters into the cavity. We find that the model reproduces the most distinctive features of the observed seasonality and offers a plausible explanation for those features. The most saline shelf waters are produced in the far west, where the inflow to the cavity peaks twice each year. The major peak occurs during the short period around midwinter when convection reaches full depth and the densest waters are generated. Once the surface density starts to decline, dynamic adjustment of the restratified water column leads to a gradual fall in the salinity at depth and a secondary peak in the inflow that occurs in summer at the western coast. Beneath the ice shelf the arrival of the wintertime inflow at the instrumented sites is accompanied by a rapid warming, while the slower decline in the inflow leads to a more gradual cooling. Water brought in by the secondary, summer peak flows mainly to the eastern parts of the cavity. Here the seasonality is suppressed because the new inflows mix with older waters that recirculate within a topographic depression. This pooling of waters in the east, where the primary outflow of Ice Shelf Water is generated, dampens the impact of seasonality on the local production of Weddell Sea Bottom Water.

Ice shelves around Antarctica are vulnerable to an increase in ocean-driven melting, with the melt rate depending on ocean temperature and the strength of flow inside the ice-shelf cavities. We present measurements of velocity, temperature, salinity, turbulent kinetic energy dissipation rate, and thermal variance dissipation rate beneath Pine Island Glacier ice shelf, West Antarctica. These measurements were obtained by CTD, ADCP, and turbulence sensors mounted on an Autonomous Underwater Vehicle (AUV). The highest turbulent kinetic energy dissipation rate is found near the grounding line. The thermal variance dissipation rate increases closer to the ice-shelf base, with a maximum value found ∼0.5 m away from the ice. The measurements of turbulent kinetic energy dissipation rate near the ice are used to estimate basal melting of the ice shelf. The dissipation-rate-based melt rate estimates is sensitive to the stability correction parameter in the linear approximation of universal function of the Monin-Obukhov similarity theory for stratified boundary layers. We argue that our estimates of basal melting from dissipation rates are within a range of previous estimates of basal melting.

We use new data from the southern Weddell Sea continental shelf to describe water mass conversion processes in a formation region for cold and dense precursors of Antarctic Bottom Water. The cruises took place in early 1995, 1998, and 1999, and the time series obtained from moored instruments were up to 30 months in length, starting in 1995. We obtained new bathymetric data that greatly improve our definition of the Ronne Depression, which is now shown to be limited to the southwestern continental shelf and so cannot act as a conduit to northward flow from Ronne Ice Front. Large-scale intrusions of Modified Warm Deep Water (MWDW) onto the continental shelf occur along much of the shelf break, although there is only one location where the MWDW extends as far south as Ronne Ice Front. High-Salinity Shelf Water (HSSW) produced during the winter months dominates the continental shelf in the west. During summer, Ice Shelf Water (ISW) exits the subice cavity on the eastern side of the Ronne Depression, flows northwest along the ice front, and reenters the cavity at the ice front's western limit. During winter the ISW is not observed in the Ronne Depression north of the ice front. The flow of HSSW into the subice cavity via the Ronne Depression is estimated to be 0.9 ± 0.3 Sv. When combined with inflows along the remainder of Ronne Ice Front (reported elsewhere), sufficient heat is transported beneath the ice shelf to power an average basal melt rate of 0.34 ± 0.1 m yr−1.

Ice shelves in the Amundsen Sea Embayment have thinned, accelerating the seaward flow of ice sheets upstream over recent decades. This imbalance is caused by an increase in the ocean-driven melting of the ice shelves. Observations and models show that the ocean heat content reaching the ice shelves is sensitive to the depth of thermocline, which separates the cool, fresh surface waters from warm, salty waters. Yet the processes controlling the variability of thermocline depth remain poorly constrained. Here we quantify the oceanic conditions and ocean-driven melting of Cosgrove, Pine Island Glacier (PIG), Thwaites, Crosson, and Dotson ice shelves in the Amundsen Sea Embayment from 1991 to 2014 using a general circulation model. Ice-shelf melting is coupled to variability in the wind field and the sea-ice motions over the continental shelf break and associated onshore advection of warm waters in deep troughs. The layer of warm, salty waters at the calving front of PIG and Thwaites is thicker in austral spring (June–October) than in austral summer (December–March), whereas the seasonal cycle at the calving front of Dotson is reversed. Furthermore, the ocean-driven melting in PIG is enhanced by an asymmetric response to changes in ocean heat transport anomalies at the continental shelf break: melting responds more rapidly to increases in ocean heat transport than to decreases. This asymmetry is caused by the inland deepening of bathymetry and the glacial meltwater circulation around the ice shelf.

Mass loss from the Antarctic Ice Sheet to the ocean has increased in recent decades, largely because the thinning of its floating ice shelves has allowed the outflow of grounded ice to accelerate. Enhanced basal melting of the ice shelves is thought to be the ultimate driver of change, motivating a recent focus on the processes that control ocean heat transport onto and across the seabed of the Antarctic continental shelf towards the ice. However, the shoreward heat flux typically far exceeds that required to match observed melt rates, suggesting that other critical controls exist. Here we show that the depth-independent (barotropic) component of the heat flow towards an ice shelf is blocked by the marked step shape of the ice front, and that only the depth-varying (baroclinic) component, which is typically much smaller, can enter the sub-ice cavity. Our results arise from direct observations of the Getz Ice Shelf system and laboratory experiments on a rotating platform. A similar blocking of the barotropic component may occur in other areas with comparable ice–bathymetry configurations, which may explain why changes in the density structure of the water column have been found to be a better indicator of basal melt rate variability than the heat transported onto the continental shelf. Representing the step topography of the ice front accurately in models is thus important for simulating ocean heat fluxes and induced melt rates.

Sub-ice shelf circulation and freezing/melting rates in ocean general circulation models depend critically on an accurate and consistent representation of cavity geometry. Existing global or pan-Antarctic data sets have turned out to contain various inconsistencies and inaccuracies. The goal of this work is to compile in- dependent regional fields into a global data set. We use the S-2004 global 1-minute bathymetry as the backbone and add an improved version of the BEDMAP topography (ALBMAP bedrock topography) for an area that roughly coincides with the Antarctic continental shelf. The position of the merging line is individually chosen in different sectors in order to get the best out of each data set. High resolution gridded data for upper and lower ice surface topographies and cavity geometry of the Amery, Fimbul, Filchner-Ronne, Larsen C and George VI Ice Shelves, and for Pine Island Glacier are carefully merged into the ambient ice and ocean topographies. Multibeam survey data for bathymetry in the former Larsen B cavity and the southeastern Bellingshausen Sea have been obtained from the data centers of Alfred Wegener Institute (AWI), British Antarctic Survey (BAS) and Lamont-Doherty Earth Observatory (LDEO), gridded, and blended into the existing bathymetry map. The resulting global 1-minute topography data set (RTopo-1) contains maps for upper and lower ice surface heights, bedrock bathymetry, and consistent masks for open ocean, grounded ice, floating ice, and bare land surface.

We present Bedmap2, a new suite of gridded products describing surface elevation, ice-thickness and the seafloor and subglacial bed elevation of the Antarctic south of 60° S. We derived these products using data from a variety of sources, including many substantial surveys completed since the original Bedmap compilation (Bedmap1) in 2001. In particular, the Bedmap2 ice thickness grid is made from 25 million measurements, over two orders of magnitude more than were used in Bedmap1. In most parts of Antarctica the subglacial landscape is visible in much greater detail than was previously available and the improved data-coverage has in many areas revealed the full scale of mountain ranges, valleys, basins and troughs, only fragments of which were previously indicated in local surveys. The derived statistics for Bedmap2 show that the volume of ice contained in the Antarctic ice sheet (27 million km3) and its potential contribution to sea-level rise (58 m) are similar to those of Bedmap1, but the mean thickness of the ice sheet is 4.6% greater, the mean depth of the bed beneath the grounded ice sheet is 72 m lower and the area of ice sheet grounded on bed below sea level is increased by 10%. The Bedmap2 compilation highlights several areas beneath the ice sheet where the bed elevation is substantially lower than the deepest bed indicated by Bedmap1. These products, along with grids of data coverage and uncertainty, provide new opportunities for detailed modelling of the past and future evolution of the Antarctic ice sheets.